How to Add Windshield Washer Fluid in Toyota Corolla 2020 - 2023
Where windshield washer fluid reservoir is located?
Steps to top up Windshield Washer Fluid in Toyota Corolla
1. Locate the Hood Release Lever - inside your Toyota Corolla, find the hood release lever, usually located near the driver's side footwell.
2. Open the Hood
Pull the hood release lever to pop the hood open slightly.
Exit the vehicle and find the secondary hood release latch under the front of the hood.
Lift the hood and secure it with the hood prop rod, if available.
3. Locate the Windshield Washer Fluid Reservoir
Look for a translucent container with a blue cap, often labeled with a windshield or water icon.
4. Remove the Cap
pop off the blue cap from the windshield washer fluid reservoir.
5. Check Fluid Level
Check the fluid level by looking at the markings on the side of the reservoir. If it's low, proceed to the next step.
6. Prepare to Fill
Place a funnel over the reservoir opening if you have one. This makes it easier to pour the fluid without spilling.
7. Fill the Reservoir
Slowly pour the windshield washer fluid into the reservoir until it reaches the "Full" line or is about an inch from the top.
8. Replace the Cap
Securely place the cap back on the reservoir and make sure it's tightly closed.
9. Test the Fluid
Start your Toyota Corolla and activate the windshield washer fluid to ensure it sprays properly.
10. Close the Hood
Carefully lower the hood and make sure it latches securely.
11. Clean Up
Use a cloth or paper towel to wipe up any spills.
Store any remaining windshield washer fluid in a cool, dry place.
Safety Tips:
Always use windshield washer fluid suitable for your climate. Water alone can freeze in cold weather or leave streaks.
Wear gloves to protect your hands from any chemicals in the fluid.
Make sure the engine is off and the car is parked on a level surface.
My Gears and Deals: https://www.amazon.com/shop/hummansunson
As an Amazon Associate I earn from qualifying purchases
Comments
Post a Comment